This is a library for the SC16IS750/SC16IS751/SC16IS752 series of UART interfaces by NXP as used on the NOS8007 interface module. Although the library is designed with NOS8007 in mind it may work with ...
Abstract: This paper presents the design of an Intellectual Property (IP) that converts a serial output signal into a parallel output signal for a liquid crystal display (LCD). The IP is intended for ...
I am a big fan of Raspberry Pi Pico microcontroller development board. I have designed lots of projects with it using MicroPython programming language. Here again I am going to create a new project ...
Abstract: The biggest challenge in analysis IoT is a complex combination of communication networks. In addition, limited resources are the cause of the failures that cause communication failure. This ...
I2C is a two-wire, bidirectional bus protocol that enables effective communication between one master (or multiple masters) and one or more slave devices. It is a straightforward, half-Duplex, ...
The Advanced KeyPad Library is used to connect a 4x4 Kepad by using a PFC8574 I2C-Interface. The Programming Interface is based on the I2CKeyPad library by Rob Tillaart, but with a complete new ...
Modern MCU boards offer a lot of performance and a high level of programming convenience. The over-the-air (OTA) feature is particularly interesting. However, transmitting serial data wirelessly ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results